-
Intelligent Signal SystemProtable Smart cellphone jamming control system. Model: AAT-SMART-J3
-
Rifle Drone Detection CountermeasureC-UAS Low-altitude Defense All in one Rifle Drone Detection CountermeasureModel:AAT-R-DC8
-
SDR Drone Detection100MHz to 6200MHz Handheld SDR Identification drone with object tracking detectionModel:AAT-DR-120H
-
FPV Drone DetectorFPV Drone Detector 300MHz-6200MHz Handheld Portable Drone 360˚ Omnidirectional Detect finder . Model: AAT-DT04-FPV
-
TDOA Drone Detection FinderTDOA+AOA Integrated direction finding and positioning drone detectorModel: AAT-TDOA-1D
-
Drone Navigation DecoysDrone navigation decoys defensive base stations . Model: AAT-D-ND01S
-
Drone Detection SystemAAT-1200-01 Drone detection all-in-one integrates the SENSOR and the detection antenna, which is convenient for installation and deployment.
-
Anti Drone Detection SystemBased on smart spectrum technology (artificial intelligence in the radio field), it can passively perceive the characteristics of DRONE signals and identify and locate DRONEs.
May 05, 2021 · Capture raw RF 433Mhz signals without sound card. I would like to use arduino and RF 433Mhz receivers to capture RF signals from any RF remote control. I actually can...
Capture the Signal (CTS) is a new challenge-based CTF that focuses exclusively on the reverse engineering of radio signals. This activity is also known as “blind signal analysis” as the signals'...
Jul 02, 2012 · There are two hurdles to overcome with this method. The first is to make sure your RF module operates on the proper frequency. The second is to get your hands on the codes that are...
Hardware – Some device is capable of just capturing/receiving the signal and some are capable of transmitting and receiving the signal. A device which can receive/capture the signal is called as a...
Mar 28, 2022 · Figure 1 shows the general principle of Signal Capture. An RTL-SDR Source block is connected to a File Sink and QT GUI Sink. Several variables are present: Sample Rate: Set to desired...
After uploading the sketch, connect an 433MHz RF receiver to Digital Pin 2 of your Arduino UNO board: Decode RF Signals (codes) Open the Arduino IDE serial monitor and start pressing the buttons. As...